Mack Trucks — PV776-21394653.pdf

Operator’s Manual Vehicle Maintenance CXU, CHU, GU, TD, MRU and LEU 83 Damage to the air filter element, such as holes in the filter medium, will give an inaccurate restriction reading. Therefore, even if maximum restriction is not indicated, the air filter element should be changed yearly or at 160 000 Km (100,000 mile) intervals, whichever comes first. When replacing the air filter element, or whenever the air inlet system has been disassembled, inspect the inlet air ducts between the air cleaner canister outlet and the turbocharger inlet as follows: Inspect the rubber elbows for cracks, splitting and/or holes.

Rubber components must be flexible so that they conform to the plastic ducts and ensure a tight seal. Inspect plastic ducts for cracks and/or holes. Ensure that all hose clamps are properly installed and tightened to specifications. Make sure the plastic ducts do not rub against any components such as air conditioning hoses, wire harnesses, etc. To properly install a new filter element: 1 Wipe the air cleaner housing clean. 2 Remove the filter element(s). 3 Inspect sealing areas for dirt tracks which would indicate that dust has leaked past the seal. If dirt tracks are found, the cause must be determined and corrected.

4 Thoroughly clean the inside of the air cleaner canister with a damp cloth or vacuum cleaner. 5 If equipped with a metal canister, inspect inside the canister for rust. If rust is present: 1 Remove the air cleaner canister from the chassis. 2 Remove all loose rust with a wire brush or a coarse Scotch Brite pad. 3 Sand with 180/240 grit wet or dry sand paper. 4 Thoroughly wash the area with PPG DX-440, DX-436, DX-437 or equivalent, wax and grease remover and wipe dry. 5 Prime immediately with PPG DEP-351 epoxy primer. 6 Reinstall the air cleaner canister. 6 Inspect the sealing areas of the housing for damage. Repair or replace as necessary.

7 Use MACK-approved replacement elements and gaskets. Make sure the new elements and gaskets are not damaged. Be sure to use new gaskets each time the element is changed. Install the cover and, depending upon cover configuration, tighten as follows: Air cleaner with large wing nut in center of cover hand-tighten wing nut. Air cleaner with three thumb screws around outer edge of cover hand-tighten thumb screws. Air cleaner with retaining nuts around outer edge of cover tighten retaining nuts between 11 – 14 Nm (8 – 10 lb-ft).