mercedes-benz — Checking

01 Engine 0115 Engine unit 1044-004 1 1 2 3 2 183104-001 113 ►Check the main and flange bearing covers. ►In case of damage (see arrow) on the main and flange bearing cover or on the dowel pins (2), the crankshaft and the dowel pins on the flange bearing covers must be replaced. ►When dowel pins (2) are worn or too short, never replace only the thrust washers (3). Thrust washers may come loose when dowel pins are too short and cause engine damage. II ►Measure the maximum radial runout (b) of the crankshaft on the centre main bearing journal, using special tools (II), (III) and (IV). Radial runout: Page 99 ►If the value is outside of the tolerance, the crankshaft must be replaced.

►Measure the diameter of the main and flange bearing journals (c) at three different positions offset by around 60°. Diameter: Page 99 Calculate the mean value of the three measurements. IV III 114 183114-001 ►Check the inner diameter of the main and flange bearings (f). Inner diameter: Page 99 ►All main bearing journals and flange bearing journals must have the same machining level. ►Insert bearing shells (2) according to the marks. ►Bolt down main and flange bearing covers (1) according to the marks. ►Measure the inner diameter (f) at three different positions offset by around 60°. ►Calculate the mean value of the three measurements. ►Unscrew main and flange bearing cover (1) again.

2 1 f 183125-001 115 00 0296 433 2 - RHB Dieselmotor OM906/926LA - 10/2014 105