mercedes-benz — Removal

01 Engine 0120 Cylinder head / Valves / Idler gear 1044-004 Removal ►Drain coolant. Page 198 ►Remove the valve cover. Page 119 ►Remove the exhaust manifold. Page 214 ►Remove the intake housing. Page 232 ►Remove the cylinder head injection line. Page 155 ►Remove the cylinder head leakage line. ►Remove the urea dosing unit. Page 277 ►Remove the urea heater valve. Page 264 ►Remove the rocker arm mechanism. Page 134 124 00 0296 433 2 - RHB Dieselmotor OM906/926LA - 10/2014 Value CCN Remark / designation 3 Cylinder head bolt – Check shaft length (a). – Slightly coat the threads and the contact faces of cylinder head bolts with engine oil. – Screw in cylinder head bolts with special tool (I).

– Tighten cylinder head bolts in the specified order (3.1 - 3.14) in 6 steps as specified. Tightening specification: 1 20 Nm 2 70 Nm 3 170 Nm 4 280 Nm 5 90 °C 6 90 °C When a cylinder head bolt is tightened too much, unscrew all bolts. Check if the bolt in question has the allowed shaft length (a). a 149 mm Shaft length of cylinder head bolt Permitted value: up to 151 mm b 0.02 mm Allowed deviation of levelness of lower separating face in longitudinal direction over a 150 mm length b 0.07 mm Allowed deviation of levelness of lower separating face in longitudinal direction over the total length c 107.9 to 108.1 mm Height of cylinder head Permitted value:

106.9 mm d 1.1 to 1.5 mm Valve depth allowed difference between the intake valves: 0.3 mm Tightening torques not specified, see section on tightening torques