01 Engine 0120 Cylinder head / Valves / Idler gear Installation 1044-004 ►Measure the bore diameter (c) for the valve guide on the cylinder head. Bore diameter: Page 144 ►Select the valve guide (1) with the next bigger deviation. ►Check the outer diameter (b) of the new valve guide (1). Outer diameter: Page 144 ►Expand the bore diameter (c) to the corresponding deviation (e.g. Ш 14.2 mm H7), using a reamer (2). ►Turn the reamer only clockwise! ►Mark valve guides and bores belonging together accordingly. 2 1 c 1 234596-001 182 Use special tools (III) and (IV). Page 142 1 IV IV ►Cool down the new valve guides (1) heavily. ►Drive in the cooled valve guides (1) as marked. Clearance (d):
Page 144 ►Observe the marking of special tools (IV) for intake and exhaust valves. ►The installation position of special tool (IV) defines the clearance (d) between the valve guide top edge and the valve spring contact surface. 183 234597-001 Use special tool (II). Page 142 ►Expand the new valve guides (1) step by step to Ш 7.95 mm max., using an adjustable reamer. ►Expand valve guides with a reamer Ш 8 mm H7. ►Turn the reamer only clockwise. ►Clean the bore of valve guides with a cylinder brush. ►Check bore of valve guide with special tool (II). 1 184 234598-001 146 00 0296 433 2 - RHB Dieselmotor OM906/926LA - 10/2014