01 Engine 0130 Lubricating oil system ►Unscrew screw plug at (1). 1044-004 ►Screw on special tool (I) at (1). I 1 235339-001 229 ►Fill the oil container of special tool (I) with engine oil according to the instructions in the Operator's Manual of the machine in question. ►Charge the oil container of special tool (I) to an excess pressure of around 3 bar, using the built-in hand pump. ►Open shut-off valve on special tool (I) until around 4 litres of engine oil were pumped into the oil channels and the engine oil comes out of the bores (see arrows) of the rocker levers (1) without bubbles. ►Do not let the pressure in the oil container drop below 1.5 bar.
►Do not empty the oil container completely as otherwise air is pushed into the lubricating oil system. 1 1 185732-001 230 ►Remove special tool (I). ►Screw on screw plug at (1). Tightening torque: Page 184 I 1 235339-001 231 ►Install the cylinder head valve cover. Page 119 ►Check the engine oil level as specified in the Operator's Manual in question. 00 0296 433 2 - RHB Dieselmotor OM906/926LA - 10/2014 179