mercedes-benz — Installing the radial seal

01 Engine 0130 Lubricating oil system ►Remove the radial seal. 1044-004 ►Remove the oil pump unit from the housing. When run-in traces and wear are found on the oil pump unit or on the housing, the oil pump must be replaced. Installation ►Clean the sealing faces. Page 19 ►Install the oil pump unit into the housing. Tightening torque: Page 19 ►Install the radial seal. Page 70 Use special tool (I). Page 193 ►Coat the sealing face of oil pump (1) with LOCTITE 510. ►Place special tool (I) on the crankshaft flange. 1 ►Bolt down the oil pump (1). ►Ensure that the radial seal (2) is not damaged. Tightening torque: Page 194 I 2 235399-001 260 ►Install the oil suction tube. Tightening torque:

Page 194 ►Install the oil pan. Page 65 ►Install the oscillation damper Page 109 ►Pre-fill the lubricating oil system. Page 178 ►Top up engine oil as specified in the relevant Operator's Manual. Installing the radial seal Use special tool (I). Page 193 a ►Push in the radial seal (1) dry, with parallel axles and evenly around all its circumference. The depth (a) is specified by special tool (I). I 1 1 235400-001 261 00 0296 433 2 - RHB Dieselmotor OM906/926LA - 10/2014 195