mercedes-benz — Installation

01 Engine 0135 Cooling system Checking 1044-004 ►Hang the coolant thermostat (1) into a container filled with water. ►Heat up the water. 1 ►Measure the water temperature and watch the opening start of the coolant thermostat. ►Observe the temperature value (a). Page 208 ►Starting at approx. 8 °C below the opening start, the water heating rate must not exceed 1 to 2 °C per minute. ►Continue heating the water until the short circuit valve (3) is closed. ►Observe the temperature value (c). Page 208 ►Continue heating the water until the main valve (2) is completely open. ►Observe the temperature value (b). Page 208 ►Remove coolant thermostat and let it cool down until the main valve is closed.

►Check dimension (d). Page 208 2 1 3 185928-001 285 Installation ►Place new seals (2) on the coolant thermostats (1). Slightly grease the sealing rings. ►Install coolant thermostats (1). ►The marks (3) must point upwards. 236003-001 286 ►Insert the thermostat housing (2). ►Screw in bolts (1). Tightening torque: Page 208 287 236001-001 ►Install the fuel filter housing. Page 175 210 00 0296 433 2 - RHB Dieselmotor OM906/926LA - 10/2014 3 1 2 1 2 23 1 2