01 Engine 0115 Engine unit 1044-004 Removal ►Remove oil pan. Page 63 ►Remove the oil spray nozzles. Page 182 ►Remove the cylinder head. Page 124 ►Ensure that all bores on the separating face of the crankcase are tightly closed. ►Fit a direction arrow indicating the installation position of the piston. ►This is required only when the direction arrow is no longer visible. ►The direction arrow must point against the power output side. ►Mark the cylinder number on the piston head. ►This is required only if more than one piston is removed. ►Twist crankshaft until the piston is at the BDC. See Cranking the engine. Page 54 ►Protect piston head and crankcase against dirt.
00 0296 433 2 - RHB Dieselmotor OM906/926LA - 10/2014 85 Value CCN Remark / designation 1 Piston Marking (1.1) for installation position and installation point. 2 Cylinder liner is not provided! 3 Piston ring - double trapezoidal ring 4 Piston ring - tapered compression ring with inside angle 5 Piston ring - chamfered ring with coil spring 6 Connecting rod Page 91 7 Crankshaft Page 98 8 Oil spray nozzle Page 181 9 Slightly coat piston pin with engine oil a Height play of piston rings is not provided! b Push play of piston rings Piston ring (3): 0.40 to 0.60 mm Piston ring (4): 0.40 to 0.60 mm Piston ring (5):
0.25 to 0.50 mm c 0.280 to 0.500 mm Piston excess dimension Tightening torques not specified, see section on tightening torques