01 Engine 0115 Engine unit 1044-004 Checking ►Measure the diameter of cylinder bore (a) in the unused section above the upper point of return of the first piston ring. Carry out measurement in direction of measurement (x) and (y). Observe the deviation from the cylinder shape (c). ►Measure the wear of cylinder track at measuring points (1) and (2), in measuring direction (x) and (y) in each case. ►Measure the crankcase height (b). x y When the largest allowed diameter is exceeded, replace the crankcase. 1 The cylinder bore and the crankcase height may only be jointly machined and must meet the same dimensional category. Otherwise assigning the pistons is not possible.
x y 2 Incorrectly assigned pistons may cause engine damage. 100 188672-001 00 0296 433 2 - RHB Dieselmotor OM906/926LA - 10/2014 95 Value CCN Remark / designation b Crankcase height Standard: 298.33 to 298.40 mm Deviation -0.3: 298.03 to 298.10 Deviation -0.6: 297.73 to 297.80 Deviation -0.9: 297.43 to 297.50 c up to 0.1 mm Wear of cylinder bore at the upper point of return of the first piston ring 0.012 mm Maximum deviation of cylinder shape Tightening torques not specified, see "Introduction / Tightening torques" chapter