Driving and Operation discs and brake pads, and the braking effi- ciency will be reduced. You should lightly press the brake pedal a few times, remove the salt layer from the brake discs and brake pads. When the gear lever is in the forward position and the vehicle is ON a down- hill slope (nose facing downward), the vehicle can maintain the current speed (2WD models: 8km/h ≤ controlled speed ≤ 35km/h, 4WD models: 4km/h ≤ controlled speed ≤ 35km/h) without the need for braking or acceleration. At this time, the (green) indicator light flashes in the instrument cluster . The driver can change the vehicle speed by applying the brakes or accelerating.
The hill descent control function auto- matically deactivates when the vehicle speed is ≥ 60km/h, and the indicator on the combination instrument (green) goes off. standby state. The (green) indicator light in the instrument cluster is ON. When the Hill Decent Control function is ON standby: The wear of brake friction plates depends to a great extent on the use mode and driving conditions, especially for those cars that often travel in urban traffic and short distances or drive in sports mode. Therefore, it is very necessary to check the brake pad thickness within the specified maintenance intervals.
Factors affecting the braking effect Worn Due to the mountainous environment, high hills and long slopes, the brakes are used frequently and for a long time, and they often work continuously under high-intensi- ty braking conditions. These factors will make the braking performance worse. Therefore, when the vehicle is going down- hill, never coast in neutral and avoid frequent braking. Try to control the vehicle speed as much as possible, which can reduce the working intensity of the wheel brakes and reduce the brake temperature.
When using engine-assisted braking, the lower the transmission gear and the higher the engine speed, the greater the drag force generated and the more obvious the braking effect. Salt road Mountain environment Wet road On wet roads, driving through standing water or heavy rain,or after washing the vehicle, can result in moisture on the brake discs and brake pads. In low-temperature conditions during winter, this can lead to reduced brake performance. To rectify this, gently depress the brake pedal a few times to dry the brakes and restore their perfor- mance.
Click the hill descent control switch again to turn off the hill descent con- trol function, and the (green) indicator light goes out on the instrument cluster . Salted roads: When driving on salted roads, if the brakes are not used for a long time, there will be a layer of salt on the brake Driving and Operation | 139