Driving and Operation Avoid fully depressing the throttle pedal for rapid acceleration. Within the initial 500 km, please avoid emergency braking. During the break-in period, avoid running Be sure to avoid high-speed engine oper- ation and do not exceed 80% of the maxi- mum speed. Do not tow other vehicles. At 1000-2500km, the engine speed and vehicle speed can be gradually increased to the highest allowable range. During the initial break-in phase, the internal friction resistance of the en- gine is much higher than that after break-in, and the engine oil consumption may be higher than the normal one. Regular checks of the engine oil should be performed.
All the moving parts of the engine must be run New tires and brake pads that have not been run-in have not reached optimal adhesion and friction, so you must drive Danger accidents. You should also follow these recommen- dations when the brake pads are replaced. Keep an appropriate vehicle-to-vehicle distance and try to avoid emergency braking while driving. Because the tires and brake pads have not been run-in at this time, adhesion and friction are in- sufficient, which can easily cause traffic accidents. of time. Implement the operational regulations strictly and keep the engine at normal working temperature.
Do daily vehicle maintenance work carefully, check fre- quently, and pay attention to the sound and temperature changes of each assembly during operation. Breaking in engine Breaking in tires and brake pads If the engine has been run in according to the requirements, its service life can be prolonged and its fuel consumption can be reduced. All new engines or overhauled engines must under- go a break-in period before normal use, and the following rules must be observed during this period: To break in new tires, drive at moderate speeds Attention If the vehicle has had the engine or other components of the transmission system replaced, the break-in precautions should also be observed.
brake discs cannot reach the optimal friction state. Emergency braking should be avoided maintained. Driving and Operation | 183