Maintenance Attention Promptly remove small stones embedded in the tire treads to avoid affecting tire perfor- mance. It is recommended to wax the wheels to reduce corrosion caused by pollutants. Cleaning of chrome plated parts Regularly clean chrome-plated parts with a non-abrasive chrome polish to maintain their shine. Internal cleaning Do not use bleach, dyes, or chemical solvents to clean the seat belt webbing as they can cause severe damage to it. Thoroughly clean the vehicle before ap- plying wax. Avoid using wax that contains abrasives, additives, or cleansers, as they may harm the vehicle’s paintwork.
Foot Mat No matter what kind of foot pad is used, it - Attention hindering the pedal operation. Avoid using cleaners that contain strong acid or alkali components to clean the wheels, as they may corrode the alumi- num alloy wheel rims. After using a cleaner, rinse the wheels within 15 minutes to completely remove the cleaner and prevent any residue from leaving marks on the aluminum alloy wheel rims. Danger Wipe the glass inside your vehicle operation of the brake pedal and acceler- ator pedal if the floor mats slip, causing serious accidents.
When wiping the interior glass, avoid using tools with sharp blades or chlorine disinfectants as they can damage the defogger wires on the rear windscreen. In winter, when the interior glass fogs up, you may spray a suitable amount of specialized an- ti-fogging agent on it to prevent fogging. Corrosion protection Ensure the vehicle is protected from corro- sion. Wheels: While cleaning the vehicle, it is important to clean the inner side of the wheels. Do not use abrasive cleaners when cleaning the wheels. Check the rim rim regularly for deforma- tion or erosion. Deformation or erosion can cause air leakage of the wheel or damage to the tire edges.
Due to the corrosive nature of road antifreeze and deicing agents, they can accelerate the corrosion and aging of underbody components such as the exhaust system, brake lines, floor panels, and fenders. Therefore, the underside of the vehicle should be promptly cleaned after driving on such road surfaces. Other rust and corrosion prevention measures Seat safety belt The seat belt webbing can be scrubbed with a After cleaning, the seat belt webbing should be air-dried before reuse,Do not directly retract the wet webbing into the retractor to avoid damag- ing the retractor. Maintenance | 205