Maintenance Wheel & Tire Wheel dynamic balance inspection When removing the battery, make sure all electrical are turned off in the vehicle. Disconnect the Intelligent Battery Sensor Attention Wheel appearance inspection The tires were properly balanced by the fac- tory,The balance of your tires is dependent on many factors which can cause wheel imbalance . Wheel imbalance can result in wheel oscil- lation, abnormal tire wear, and compromised driving stability. Therefore, it is recommended to regularly visit an authorized dealer of Beijing Automotive to have the wheel balance checked.
All wheels should be inspected before driving, and tires should be checked regularly for bulg- es, scratches, abnormal wear, cracks, nails, etc. If the above phenomenon occurs, please contact a BAIC authorized dealer for inspection and replacement. Some tire damage may not be easily detected. If you notice abnormal vibrations, noises, or vehicle deviation while driving, there may be a tire issue. At this moment, immediately pull over under safe conditions to inspect the wheels and tires for any damage. If necessary, contact a BAIC authorized dealer for maintenance. Com- mon causes of tire damage: Striking or rubbing the shoulder;. Drive quickly through the deep hole in the road.
The air pressure is lower or higher. Regularly check tire tread depth and tread con- cable, and then remove the positive cable. Before turning it on again, make sure that all electrical are turned off in the vehicle. connect the negative cable. Only the original battery can be replaced. Replacing batteries with other non-stan- dard models may result in incorrect bat- tery sensor information and functional failure. Removing and installing the battery requires certain professional skills and tools, as mishandling may damage the battery or the fuse box under certain cir- cumstances. It is recommended to go to a BAIC authorized dealer to replace the battery.
Replacement of tire If there is one of the following conditions, the tire shall be replaced as well: Tire wear indicator marks have been worn. You can see the cord or cord fabric in the tire rubber. The tread or sidewall is cracked, and the crack is deep enough to see the cord fabric or cord. The tire is bulged, swelled or layered. The tire is punctured, scratched or other- wise damaged, and the size and location of - face will reduce tire adhesion. This will partic- ularly increase the risk of hydroplaning on wet The tire age reaches 6 years from the date of production. driving safety. Maintenance | 243