Maintenance regeneration process will fully burn the partic- ulate matter and keep the GPF in a stable and effective working state. During the regeneration process, it is recom- mended to drive the vehicle under the following driving conditions until the alarm message is eliminated and regeneration is completed (for ease of viewing, please do not block the alarm message during this period). Try to drive at a constant speed on roads with good traffic conditions, while main- taining a speed of >80km/h. Do not idle the engine. Do not stop the vehicle or turn off the en- gine.
High temperatures will be generated during the regeneration process, and it is Danger Attention If the driving conditions are not satisfac- tory and the vehicle cannot automatically start the regeneration program for a long time, the Particulate Filter in the instru- ment cluster needs to light up the regen- eration indicator light. The instrument cluster prompts "GPF needs to be regen- erated.
It is recommended that the user drives the vehicle at high speed or goes to a service station for processing." At this time, you need to start the vehicle and wait until the water temperature reaches the normal operating temperature (the water temperature indicator bar should indicate near the middle position), then drive the vehicle according to the driving conditions in the regeneration program to start the regeneration program. Failure to follow the above operations will affect the normal operation of the engine and Particulate Filter, and may cause damage to vehicle components. - tomatic regeneration procedure. in the exhaust pipe, gasoline particulate filter or heat shield.
Otherwise, it may Repair required indicator light If the particle collector requires maintenance, the corresponding indicator will remain on, and the combination instrument will display a message stating “GPF saturation, please visit the authorized service center for parking regen- eration.” It indicates that the particulate filter is faulty. In this case, please contact a BAIC authorized dealer to have the particulate filter repaired as soon as possible. Attention Regeneration procedure national regulations and standards, and do not use fuel additives, etc. Prevent an increase in particulate matter or poisoning of the catalytic converter due to oil prob- lems. oil regularly.
During driving, when the GPF reaches certain conditions, the vehicle will automatically start the regeneration process when the driving con- ditions are met. At this time, the instrument will display the prompt "GPF is actively regenerat- ing, the user does not need any operation", and in the combination instrument will ON. The 248 | Maintenance