Komatsu — LOADING AND UNLOADING WITH TRAILER

. OPERATION TRANSPORTATION LOADING AND UNLOADING WITH TRAILER WARNING Always turn the auto-deceleration switch OFF (cancel) during loading and unloading operations. If the auto-deceleration switch is left ON, the machine may suddenly 3 - 103 TRANSPORTATION When transporting the machine , observe all related laws and regulations, and be careful to TRANSPORTATION PRO CEDURE Select the method of transporta tion to match the weight and dimension s given in "SPECIFIC ATIONS (PAGE 5-2)". Note that the weight and dimen sions given in SPECIFICATIONS may differ according to th e type of shoe or arm, or other attachments. When loading a machine to a tr travel the machine at low speed.

Run the engine at low idle, set t slowly when loading or unloadin ailer or unloading from it, be sure to Never attempt to change the speed. o low speed, and operate the machine g. ading or unloading the machine. e edge of the road. Select firm, level ground when lo Maintain a safe distance from th Use ramps with ample width, len gth, thickness, and strength and install them at a maximum slope of 15° . the piled soil fully and take action to psing. the machine tracks before starting in m slipping on the ramps. is clean and free of water, snow, ice, the ramps.

There is danger that the When using piled soil, compact prevent the slope face from colla Remove all mud and dirt from order to prevent the machine fro Be sure that the ramp surface grease, or oil. Never correct your steering on machine may turn over. If necessary, drive off the ramp s, correct the direction, then enter the ramps again. Do not use the work equipment f or loading and unloading operations. It is dangerous. ate any lever except the travel lever. When on the ramps, do not oper The center of gravity of the mac hine will change suddenly at the joint between the ramps and the trac k or trailer, and there is danger of the machine losing its balance. Trav el slowly over this point.

When swinging the upper structu re on the trailer, the trailer is unstable, so pull in the work equipment an d swing slowly. If the sliding door of the cab is closed or open, always check that it is locked in position. The operatin g effort when opening or closing the door suddenly changes when th e machine is on a ramp or platform, so never open or close the door in such conditions. When loading or unloading, alw ays use ramps or a platform. Proceed