. OPERATION TROUBLES AND ACTIONS Starting the Engine CAUTION 3 - 122 NOTICE and clip should be suitable for the battery size. The size of the booster cable and clip should be suitable for the battery The battery of the normal ma chine must be the same capacity a s that of the engine to be sta The starting system for this machine uses 24 V. For the normal machine, also use a 24 V batt Check the cables and clips fo r damage or corrosion. d clips are firmly connected. both machines are in the LOCK position. e NEUTRAL position. Make sure that the cables an Check that the lock levers of both machines are in the LOCK po sition.
Check that each lever is in th Booster Cable Connection Keep the starting switch o f the normal machine and problem . machine in the OFF position Connect the booster cable a s follows, in the order of the nu mbers marked in the diagram. 1. Connect one clip of bo terminal of the problem 2. Connect the other clip o terminal of the normal m 3. Connect one clip of bo terminal of the normal m 4. Connect the other clip structure frame of the pr oster cable (A) to the positive (+) machine. f booster cable (A) to the positive (+) achine. oster cable (B) to the negative (-) achine. of booster cable (B) to the upper oblem machine. 1. 2. 3. 4. 1. terminal of the problem 2.
Connect the other clip o terminal of the normal m 3. Connect one clip of bo terminal of the normal m 4. Connect the other clip structure frame of the pr Always check that the lock lever is set to the LOCK position, regardl ess of whether the machine i s working normally or ha s failed Check also that all the control le vers are at the HOLD or neutral po sition. 1. Make sure the clips are f irmly connected to the battery t erminal s. . 2. Start engine of the norm al machine and run it at high idl e speed 3. Turn the starting switch of the problem machine to the S TART position and start t If the engine doesn't star t at first, try again after 2 minut es or so .
Booster Cable Disconnection d, disconnect booster cables in the were connected. After the engine has starte reverse order in which they 1. 2. 3. 4. 1. Remove one clip of boos ter cable (B) from the revolving frame of the problem machine. 2. Remove the other clip of booster cable (B) from the negat ive (-) terminal of the normal m achine. oster cable (A) from the positive (+) achine. 3. Remove one clip of bo terminal of the normal m 4. Remove the other clip of booster cable (A) from the positi ve (+) terminal of the problem machine.