. MAINTENANCE OUTLINE OF SERVICE 4 - 5 FUEL To prevent the moisture in the air from con densing and forming water inside the fuel tank, always f ill the fue l tank after completing the day's work. nd if fuel containing water or dirt is used, it cannot work properly. get in when storing or adding fuel. ation and Maintenance Manual. The fuel pump is a precision instrument, a nd if fuel containing water or dirt is used, it cannot wor k properly Be extremely careful not to let impurities Always use the fuel specified in the Oper Fuel may congeal depending on the temp erature when it is used (particularly in low temperature below -15 °C (5 ° F)).
It is necessary to use the fuel that is suitable for the temperature. Before starting the engine, or when 10 min utes have passed after adding fuel, drain the sediment and water from the fuel tank. If the engine runs out of fuel, or if the filter s have been replaced, it is necessary to bleed the air fr om the ci rcuit. If there is any foreign material in the fuel t ank, wash the tank and fuel system. COOLANT AND WATER FOR DILUTIO N preventing corrosion as well as preventing freezing. n issue, the use of antifreeze coolant is essential.
The coolant has the important function of Even in the areas where freezing is not a n issue, the use of antifreeze coolant is essential Komatsu machines are supplied with Kom atsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC ) has excellent anticorrosion, antifreeze and coo ling propertiesand can be used continuously for 2 years or 4000 h ours. Komatsu Supercoolant (AF-NAC) is stron gly recommended wherever available. distilled water or tap water (soft water).
ell water (hard water), contains large amounts of minerals (calcium, When diluting the antifreeze coolant, use Natural water, such as a river water or w ell water (hard water), contains large amounts calcium, magnesium, etc.), and this makes it easier for scale to form inside the engine or radiator. Once sca le is deposited inside the engine or radiator, it is extrem ely difficult to remove. It also causes overheating du e to poor heat exchange, so when you dilute the coolan t, we recommend that you use water with an overall hardness of less e precautions given in the Operation and Maintenance Manual. re to keep it away from flame. ater differs according to the ambient temperature.
CLEAN INSIDE OF COOLING SYSTEM (PAGE 4-21)". in premix. In this case, never add diluting water. e to cool before adding coolant. rdness o f less than 100 PPM. When using antifreeze, always observe th e precautions given in the Operation and Maintenance Manual. Antifreeze coolant is flammable, so be su The ratio of Supercoolant (AF-NAC) to w ater differs according to the ambient temperature. For details of the ratio when mixing, see " CLEAN INSIDE OF COOLING SYSTEM (PAGE 4-21) Supercoolant (AF-NAC) may be supplied in premix. In this case, never add diluting water.
If the engine overheats, wait for the engin If the coolant level is low, it will cause over heating, and will also cause problems with corrosion due to air entering the coolant. GREASE ises at the joints. er heavy-duty conditions. Always use the recommended grease and Grease is used to prevent seizure and no This construction equipment is used und follow the change intervals and recomme nded ambient temperatures given in this Operation an d Maintenance Manual. ce section are nipples for overhaul, so they do not need grease. for long time, add grease. s pushed out when greasing.
The nipples not included in the maintenan ce section are nipples for overhaul, so they do not nee d grease If any part becomes stiff after being used Always wipe off all of the old grease that i Be particularly careful to wipe off the old g rease in places where sand or dirt sticking in the greas e would c ause wear of the rotating parts.