. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE NOTICE 4 - 41 5. Bleeding air f only when o il inside travel motor case has been drai 1) Run the engine at low idle, re move hose (3) fro n the oil has flowed o engine at low idle an ut, tighten i d swing the t again. work eq ng it to the side of th he machine until the d.Rotate the track u nder no load for 2 m inutes. is procedure on both the left and right si des, and track equally both fo rward and i n rever 6. Bleeding air f rom attachment (wh en installed) NOTICE If the attachment m aker specifies an air ble eding procedure for t he attachment itself, follow the specified procedure to bleed the air.
f a breaker o r other attachment ha s been installed, ru n the engine at l ow idle a nd operate t he attachment pedal epeatedly (a pprox. 10 times) unti l the air has been b led from the attachment circuit. After completing the air bleeding opera tion, stop the engine, and leave the machine for 5 minutes befo re starting operations. This will remove the air bubbles in the o il inside the hydrauli c cylinders. Check that there is no leakage of oil an d wipe off any oil that has been spilled.