52 CAB ASSEMBLY HT220 20 40 21 6 17 16 15 17 16 1517 16 31 1 6 31 17 15 SECTION B-B SUPPLIED WITH ALL SCREWS INSIDE CABIN CABIN WELDMENT 45 47 46 ALL SCREWS INSIDE CABIN CABIN WELDMENT SUPPLIED WITH 50 9 48 27 28 34 49 B 39 52 51 53 54 55 18 19 8 36 35 SUPPLIED WITH THE ELECTRIC ENCLOSURE 4 E M E R G E N Z A A Z N E G R E M E 16 17 6 15 31 NOTES: 1) TO VERIFY THAT: - tubular frame weldments min z4. 2) IMPORTANT: - covering sheet metal weldments outside min z3. - there are to be no openings in the outside covers that allow infiltrate the cab. - Seal all holes used for the passage of electric cables with foam sealer in manner that no dust will dust or water to penetrate the inside of the cab.
- the evaporator box is sealed. - between the filters and the sheet metal there is a seal Sp. 3mm to reduce side contamination.. not need to be forced (opening and closing). - the sheet metal lower door and roof panels of the cab - the cab handle is positioned in a manner that its operation does are put on with adhesive seal. - the trim (or other) between the mobile glass of the opening window seals the passage of dust. 03 ID0183126 - the fit of the tubes are matched with the pressuriser (code 36401114). - the tubes of the pressurizer are sealed. 40 SEE VEDI 2 NOTA NOTE 2 B 20