SWITCHES loads the alarm will change to a fast beep. Turning the key switch to the ON position at anytime will reconnect loads disconnected by the LVD. 11. Brakes, ABS Off-Road Turn switch on to engage ABS Off-Road mode. See Anti-Lock Braking System on page 3-34. Do not use the Spare Battery A & B circuits or other circuits that are controlled by the LVD to power elec- tronic engine controls, ABS circuits, or safety/work-related lighting. Be- fore adding any device to the vehi- cle's electrical system, consult your nearest authorized Kenworth Dealer or read the contents of TMC RP-136. Failure to do so may cause equip- ment damage or lead to personal in- jury. WARNING!
See an authorized Kenworth Dealer if the LVD fails to reconnect loads during normal operation. 12. Brakes, Parking Brake Valve Pull yellow knob to activate parking brakes. See Parking Brake Valve on page 3-102. 3 Circuits Disconnected by LVD 13. Dump Truck Gate Turn switch on to open Dump Truck Gate. Cab Dome Lamps Cab Accessories 14. Engine, Brake Level In the up position there will be 100% engine retarding. In the middle position there will be 60% engine retarding. In the down position there will be 33% engine retarding.
Spare Battery A & B Sleeper Dome Lamps NOTE Sleeper Accessories The determination of what cir- cuits/loads that were connected to the LVD was based upon the rec- ommendation from Technology and Maintenance Council (TMC) of the American Trucking Association. To review the recommended practice, see TMC RP-136. For more information on when and how to use the engine brake in your vehicle, see the engine brake owner’s manual for additional engine brake information. NOTE All LVD circuits are color-coded blue on the central electrical panel cover label. 3-102 Y53-1203-1D1 (02/14)