PACCAR Inc. W900, T660, T800, C500, 963 — Windshield Wipers/Washer

STEERING COLUMN Windshield Wipers/Washer You cannot momentarily flash headlights when high beams are on. The headlights will flash on if they are off, if headlamps are on as low beams, headlamps dim to 25%. NOTE Your Kenworth is equipped with a two-speed, intermittent windshield wiper system. A seven-position rotary wiper switch (located on the turn-signal lever) operates the windshield wipers and washer. Rotate the end of the turn signal lever to change the wiper mode. 1 Press in for washer pump 2 Rotate to change wiper mode 3 Press button for Marker / ID Lamp flash 3 Headlight flash is not available on models with high intensity discharge (HID) headlight option.

The ignition key must be turned to ON or ACC for the wiper/washer switches to operate. NOTE Check your local state’s regulations for any restriction on the use of the high-beam flashing function. The first position after OFF is the intermittent #1 cycle. The next positions are intermittent #2, #3 and #4. The last two positions are wiper low speed and wiper high speed. See the wiper switch settings table for intermittent delay times. NOTE The ignition key must be turned to ON or ACC for the wiper/washer switch to operate. 3-114 Y53-1203-1D1 (02/14)