OPERATING THE ENGINE Starting Procedure - Cold Weather Engine Block and Oil Pan Heater (Option) Always unplug heater before starting the engine. Damage to the cooling system could occur if the heater is not turned OFF (unplugged). CAUTION In cold weather, fast engine starting helps relieve the loads on the electrical system and cranking motor. Using the special cold starting equipment will help starting. If you follow a few simple guidelines, you will extend the service life of your engine: To preheat the engine before starting, plug the optional engine block heater into a properly grounded AC electrical source. Do not start the engine with the heater plugged in.
Depending on engine make, when the temperature falls below -10° F (-24° C), the block heater is recommended. WARNING! Keep the electrical system in top condition. Engine block and oil pan heaters can cause fires which may result in death, injury and/or property dam- age if not properly maintained and operated. Regularly inspect the en- gine block heater wiring and connec- tor for damaged or frayed wires. Do not use the heater if there are any signs of problems. Contact your au- thorized dealer or the manufacturer of the heater if you are in need of re- pairs or information. Use a solution of half ethylene glycol antifreeze and half water for best heater performance.
Do not exceed 65 percent concentration of antifreeze, as a shortened heater life will result. See Engine Cooling System on page 5-61, for more information. 4 Use the best quality fuel of the recommended grade. Use recommended engine lubricating oil. For manual transmissions and auxiliary transmissions, leave the transmission in neutral and allow the transmission lubricating oil to warm up (approximately 3-5 minutes) before operating vehicle. After servicing the cooling system, operate the vehicle for a day or two before using the heater. Trapped air inside the engine needs time to escape. 4-42 Y53-1203-1D1 (02/14)