AIR SYSTEM MAINTENANCE Preventive Maintenance Remove compressor discharge valve cap nuts and check for presence of excessive carbon. If excessive carbon is found, clean or replace the compressor cylinder head. Also, check compressor discharge line for carbon, and clean or replace the discharge line if necessary. The following service checks are provided for your information only and should be performed by a certified mechanic. Contact your Kenworth Dealer or the engine manufacturer's Maintenance Manual for further information on servicing air compressors.
When draining the engine cooling system is required, to prevent dam- age from freezing, the compressor must also be drained at the cylin- der head and block. Engine dam- age could occur if the cooling sys- tem is not periodically drained and maintained. See Cooling System on page 5-61 for further information. CAUTION After completing any repairs to the air system, always test for air leaks, and check the brakes for safe operation before putting the vehicle in service. Disassemble compressor and thoroughly clean and inspect all parts. Repair or replace all worn or damaged parts, or replace compressor with a factory exchange unit.
According to Table 11, Air System Scheduled Maintenance on page 5-35: 5 Inspect compressor air filter element, if so equipped, and replace element if clogged. Check compressor mounting and drive for alignment and belt tension. Adjust if necessary. (02/14) Y53-1203-1D1 5-39