PACCAR Inc. W900, T660, T800, C500, 963 — Halogen/HID Lamp Headlamp Servicing

ELECTRICAL MAINTENANCE Projector Housing Installation 1. Verify white ring alignment. If needed, carefully rotate ring with a small blunt tool, so that the 4 grooves in the housing and ring are aligned or the device cannot be installed. 3. Push Ignition Device onto back of projector housing. 4. Rotate Ignition Device 25° clockwise until it locks into place. 5. Lastly, install the high-voltage cable to the ignition device. 2. This tab indexes with white tab on projector housing (see following Fig.).

Ignition Device Installed Ignition Device 1 Spring Grooves 2 Index Points (12 o’clock and 2 o’clock) 3 White Tab 5 Ignition Device Installation CAUTION Care must be taken to NOT install the High-voltage cable until after the Ignition device is fully installed, oth- erwise, damage may result to either the Ignition Device or the HID Bulb. Close Cover 1 White Ring 2 Tab 1. Install and rotate low-beam access cover clockwise. 5-84 Y53-1203-1D1 (02/14)