ENGINE MAINTENANCE Accessory Drive Belts Engine Fan Thermatic (Clutch) Type Fan Fan Drive and Blade You can avoid costly downtime by periodically checking belt wear and replacing worn and damaged belts. Neglect could cause belt failure. The result could be the loss of the electrical or air system as well as possible engine damage from overheating. So, it is a good idea to check the belts frequently and replace them as soon as you detect trouble. Fan Blade Clearance: Around the fan shroud, the recommended distance is 1 in. (25 mm) from front edge of any fan blade-to-radiator side member. Minimum clearance is 3/4 in. (19 mm). WARNING! Do not work on the fan with the en- gine running.
The engine fan can engage at any time without warning. Anyone near the fan when it turns on could be injured. Before turning on the ignition, be sure that no one is near the fan. Failure to comply may result in personal injury, death, equipment or property damage. Rear edge of any blade must be no closer than 3/8 in. (9 mm) to the nearest engine component. If this cannot be obtained, the fan spacer or fan is not correct. To check the fan: The leading edge of any fan blade must be 1 in. (25 mm) from the inside edge of the shroud. 5 Check the fan assembly mounting bolts for tightness. Inspect the blades for damage. Check the clutch operation by starting the engine when it is cold.
Then idle it at about 800 rpm. Listen for air leaks. 5-92 Y53-1203-1D1 (02/14)