WHAT TO DO IF... Fuse or Relay Blows Fuses, circuit breakers, and relays are located in the Power Distribution Box to the left of the steering column behind the clutch pedal. See Power Distribution Box on page 5-70. Before replacing a fuse, turn OFF all lights and accessories and remove the ignition key to avoid damaging the electrical system. CAUTION If a fuse of the same rating is not available, a fuse of a lower rating may be temporarily substituted. You can also use a fuse from a circuit you can do temporarily without (for ex- ample an accessory circuit or radio).
NOTE 2 Additional fuses for the alternator, engine electronics and trailer battery charge circuit may be located in the Power Distribution Center (PDC) inside the battery box and/ or on the engine side of the cab firewall. See Power Distribution Center (PDC) on page 5-67. CAUTION Never patch fuses with tin foil or wire. This may cause serious dam- age elsewhere in the electrical cir- cuit, and it may cause a fire. All the electrical circuits have fuses to protect them from a short circuit or overload. If something electrical on your chassis stops working, the first thing you should check for is a blown fuse.
CAUTION If a circuit keeps blowing fuses, have the electrical system inspected for a short circuit or overload by an au- thorized Kenworth dealer as soon as possible. Failure to do so could cause serious damage to the elec- trical system and/or vehicle. 1. Turn OFF all lights and accessories and remove the ignition key to avoid damaging the electrical system. Do not replace a fuse with a fuse of a higher rating. Doing so may damage the electrical system and cause a fire. Failure to comply may result in personal injury, death, equipment or property damage. WARNING! 2. Determine from the chart on the fuse panel which fuse controls that component. (02/14) Y53-1203-1D1 2-7