Komatsu — CHECKS AFTER STOPPING ENGINE

. OPERATION OPERATION CANCELING DUMP BODY HOLD CONDITION WARNING STOPPING ENGINE so never set the HOLD 3 - 89 If HOLD is can celed when the dump bod y is raised, the body will go down under its own weight. This is very dangerous. Always lower the dum p body before stopping t If the engine is stopped, the body will stay in HOLD cond ition, regardless of the position o f the dump lever. If the engine is started in this condi tion, the dump body p ilot lamp wi ll light up. Return the d ump control lever to H OLD position, then mo ve it to FLOAT position to canc el the dump body HOLD condition. mp body is set to FLOAT condition, the body pilot lamp will go out.

When the du mp body is set to FLO AT condition, the bod y pilot lamp NOTICE If the engin is danger t e is suddenly stopped without allowing it to cool do hat the life of the engine parts will be shortened, stop the en Allow the e Set the dum gine suddenly except in ngine to cool down gradu p lever to FLOAT positio emergency. ally before stopping it. n, lower the dump body, the engine. 1. Set the gear shift lever to N ( parking brake switch to PARKI 2. Lower t position. 3. Run the engine at Low idle (MI N) for approximately 5 to cool d own gradually. 4. Turn the key of starting switch (1) to OFF position to engine. the key from starting switch (1). 5.

Remove the key from starting s CHECKS AFTER STOPPING ENGINE 1. Walk aro and wat 2. Fill the fu 3. Check th 4. Remove 1. Walk aro und the machine and check the work equipm ent, bodywork, and undercarria ge, and check also for oil er leakage. el tank. e engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard. any mud affixed to the undercarriage. 2. Fill the fu 3. Check th e engine compartmen t for paper and debris. Clean out any paper and debris 4. Remove any mud affixed to the undercarriage.