. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE inside. cup (4) is at the 4 - 21 7. Blow dry compressed air (0.2 MPa {2.1 kg/cm 2}, 30.0 PSI) from the insid e of out er ele ment (6 ) along t he pleats. Next, blow along the from again from 8. After clea ning, s hine a light bu lb from in side outer elemen t (6) to check. If any replace outer ele 9. Install ou ter element ( 6) in the air clean er body 10. Check th at O-rin g (9) i s fitted t o dust cu p (4). Next, set so tha t vacuator va lve (8) of dust bottom, a nd inse rt it in to the a ir cleaner body 11. Fit 6 hoo ks (5) of dust cap (4) to the pro truding parts of th e air cleaner b ody to l ock in positio