. MAINTENANCE SERVICE PROCEDURE BLEED AIR FROM CENTER BRAKE WARNING 7. After finishing air bleeding, stop the engine (for 2 to 3 minutes), 4 - 32 Stop the machine on level ground and put blocks under the wheels before To make it easier to bleed the air, warm the oil up to a temperature of at least 40°C (104°F) before bleeding the air. Bleed the air from the center b rakes in the same way on both t he left and right sides. 1. Start the engine, check th at the oil in the transmission cas e is the specified level, and check if the retarder oi pressure caution lamp is o 2. Remove the cap installed adjuster, then insert a viny Prepare a container with o hose approx.
50 mm (2.0 i (Use any commercially av 3. Depress the brake pedal a ailable vinyl hose.) nd loosen bleeder screw (1) approx. 3/4 turns. Keep the peda come out from the vinyl ho l depressed until no more bubbles se. ever and loosen bleeder screw (1) 4. Pull the retarder control l approx. 3/4 turns. Keep t until no more bubbles com (1) he retarder control lever depressed 5. After bleeding the air, tight en bleeder screw (1) securely an d fit the cap. 6. The procedure for bleeder screw (2) of the center brake is the same as for the slack adjuster (with step 4 excluded). NOTICE The brake oil pressure caution l operation.
If this happens, tighten amp may light up during the air bleed the bleeder screw and use sight gauge (H) to check if there is oil remainin g in the brake oil tank. If there is no oil, stop the engine. (When the engin will be automatically supplied to t e is stopped, the oil level will rise and oil he brake oil tank.) and adjust the oil level so t details, see "CHECK OIL ADD OIL (PAGE 3-75)". hat it reaches the specified level. For LEVEL IN TRANSMISSION CASE,