Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE EVERY 500 HOURS SERVICE Maintenance for every 50 and 250 hours service should be carried out at the same time. CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING loosen drain valve (3) slowly to if there are excessive metal and drain valve (3) to 68.6 ± For details, see 4 - 52 mmediately after the engine is stopped , its parts and oil are still very hot, and may cause burn injury. have cooled down before starting the work. Refill amount of oil: 37 liters (9. Prepare a filter wrench and a co 1. Remove the bolts and cover (1 2. Set the oil container immediat 3.

Remove drain plug (2), then l avoid getting oil on yourself, an loosen the drain valve too far a 4. the valve. Check the drained oil, and particles or foreign material, co 5. Tighten drain valve (3) and dra Tighten both of drain plug (2) 9.8 Nm {7 ± 1 kgm, 50.6 ± 7.2 6. By using the filter wrench, turn remove it. filter cartridge (4) to the left to tting oil on yourself, do not carry ately under the cartridge. s carried out immediately after ount of oil will come out, so wait the operation. w filter cartridge with oil, coat the oil (or coat thinly with grease), When doing this, to prevent ge out this operation from immedi In particular, if this operation i stopping the engine, a large am 7.

for 10 minutes before starting Clean the filter head, fill the ne packing face and thread with then install the filter cartridge. 8. Install the filter cartridge. Whe n doing this, be careful not to damage the outside cylin When installing the filter cartrid ge, tighten until the packing face is in contact with the f further 3/4 to 1 turn. f engine oil from oil filler (F). e at idle, then check the oil if it is filled up to a specifie NE OIL PAN, ADD OIL (PAGE 3-74)". 9. Pour in the specified amount o 10. Run the engine for a short tim "CHECK OIL LEVEL IN ENGI