Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE TRANSMISSION FILTER ELEMENT WARNING REMARK 4 - 61 Immediately after the engine is sto pped, its parts and oil are still very hot , and may cause burn in jury. Accordingly, wait unti they have cooled down before star ting the work. rn it slowly to release the internal pressure, then remove it. When removing the oil filler cap, tu VALVE SIDE Prepare a filter wrench and a c 1. Place a container under the fi lter case to catch the oil. e filter head, drain the oil, then filter cartridge (2) to the left to e seal surface of the new filter then install it. m (5.5 to 6.5 kgm, 39.8 to 47.2 e "CHECK OIL LEVEL IN D OIL (PAGE 3-75)". 2.

Remove drain plug (1) at th tighten the plug again. By using a filter wrench, turn remove it. 3. 4. Clean the filter head, coat th cartridge thinly with clean oil, Tightening torque: 54 to 64 N lbft) 5. Add oil. For details, se Clean the filter head, coat th cartridge thinly with clean oil, 5. TRANSMISSION CASE, AD BRAKE COOLING SIDE cover (2). under the drain plug to catch the 1. 2. Remove bolt (1), then remove Place a container immediately oil. Remove drain plug (P), drai again. Remove the element, then w n the oil, then tighten the plug 3. ash the inside of the filter case, the strainer at the bottom of t were removed. he filter case, and the parts that install cover (2) with bolt (1).

e "CHECK OIL LEVEL IN D OIL (PAGE 3-75)". bleeder screw (3), then insert a 4. Install the new element, then 5. Add oil. For details, se TRANSMISSION CASE, AD 6. Remove the cap installed to vinyl hose. Prepare a contain er with oil in it and insert the other end of the hose approx. 50 mm oil. (Use any commercially a (2.0 in) below the surface of the vailable vinyl hose.) der screw (3) approx. 3/4 turns, 7. Start the engine, loosen blee and keep the engine running a t idling until fewer bubbles come out from the vinyl hose. perly, then install the cap. transmission case is up to the 8. Tighten bleeder screw (3) pro 9. Check that the oil level in the specified level.

If the oil level is low, add oil. 10. When the air is bled from inside t he case, the transmission oil level