. MAINTENANCE SERVICE PROCEDURE hose approx. 50 mm into a tighten bleeder screw (1) NOTICE damage to the pump. 4 - 64 9. Add oil through oil filler port (F) u ntil the oil level is between the H and L marks on s When running the engine at low idle, be careful not to let the oil level in the brake oil tank go below sight gauge (H). f the oil level goes below sight gaug e (H), stop the engine to raise the oil level in the br 10. Remove the cap from bleeder scr (Use a commercially available vi 11. Put the other end of the vinyl container of oil. 12. Loosen bleeder screw (1) approx. at low idle until no more bubbles c 13. When no more bubbles come o securely, remove the vinyl hose, 14.
Perform the warming-up operatio n of the engine until the torque converter oil temp erature gauge goes above 40°C (104°F). 15. When the torque converter oil te mperature gauge rises to 40°C (104°F), bleed the a Front brake: See "BLEED AIR F Center brake: See "BLEED AIR Do not re-use the oil drained when ble Be careful not to let the oil level in the brake oil tank go below sight gauge (H) during the air ble ed operation. This will cause 16. After completely bleeding the air f rom the brakes, stop the engine for approx. 2 - 3 mi nutes. After that, check the oil level in the transmission case LEVEL IN TRANSMISSION CAS