. MAINTENANCE SERVICE PROCEDURE LUBRICATING PARKING BRAKE WARNING parking brake from being place) in the slack adjuster. NOTICE Do not use air pressure or oil pressure to perform high-pressure greasing. REMARK Removing fitting (1) makes it possible to release the abnormal internal pressure created by excessive greasing. 7. If no grease comes out, install fitting (1). 4 - 66 When perf orming maintenance, raise t he brake oil pressure sufficie ntly to prevent the parking brak e from being automatically applied. In addition, hang a warning ta g that can be seen clearly to prevent any other person from o perating the parking brake switch. Do not get any oil or grease on the bra 1.
Stop the machine in a flat place and put the blocks under the tires to prevent the mac 2. Raise th e dump body and secure it in position with the bo dy pivot pin. ufficiently to prevent the pa 3. Before starting operations, raise the brake oil pressure s automa tically applied, and check that the brake pressure caution lamp is not lighted u 4. Release the parking brake and s 5. By usin g a grease pump, pump and (2) (2 places) in the parking 6. After co mpleting the greasing op eration, remove fitting (1) If greas e comes out, wipe off all t he grease that comes ou 8. Check t he braking capacity. For details, see "CHECK BRAKING CAPACITY OF PARKING BRAKE (PAGE 4-50)". 9.
If the ma chine moves when the br aking capacity is checked , adjust the parking brake. F or details, see "ADJUST PARKIN G BRAKE (PAGE 4-36)" .