. MAINTENANCE SERVICE PROCEDURE CHECK WEAR OF BRAKE DISC WARNING 3. Remove cap nut (1). 4. Depress the brake pedal, keep it depressed, and push in rod (2) of the gauge until it contacts the piston. 5. If mark (3) at position "A" of rod (2) enters beyond guide end face (4), it means that the disc has reached the wear limit. For the front brake, use the mark at position "A", and for the center brake, use the mark at position "B". If the disc has reached the wear limit, please contact your Komatsu distributor for inspection and maintenance. 6. Tighten cap nut (1) removed in step 3. Tightening torque:
14.7 to 19.6 Nm (1.5 to 2.0 kgm, 10.8 to 14.5 lbft) 4 - 68 Perform this check when the br ake oil temperature is below 60°C (140°F). I f the disc wear approaches the wear limit, check the condition frequently, regardless of the maintenan ce interval. In addition, check the retarder capacity car 1. Stop the machine on level ground, set the parking brake switch to PARKING position, then check that the other brakes are not applied bef ore starting inspection. and check that the retarder oil pressure caution lamp is out. 2.
Turn the starting switch ON and check that the retarder oil press If the retarder oil pressure c out, turn the starting switch aution lamp is lit, start the engine, run the engine at 2000 rpm, and if the lamp goes REMARK With new machines, the pos ition of the guide is adjusted so that m ark (5) comes to end fac e (4) of the guide, so do not loosen locknut (6) ex cept when replacing the disc. Perform the operation with t wo workers. One worker depresses th e brake pedal and the oth er pushes in the rod. If the rod is pushed in when the engine is running, the rod will be p ushed back by the brake cooling oil pressure, so always perform this oper ation with the engine stopped.
There are marks on the rod at three places (A, B, C), but for the fro nt brake, use the mark at position "A", and for the center brake, use the m ark at position "B".