. MAINTENANCE SERVICE PROCEDURE and perform the GREASING PROCEDURE FOR FRONT DRIVE SHAFT WARNING the spider, match them according to the following chocks 4 - 87 EVERY 6000 HOURS SE Maintenance for every 50, 25 0, 500, 1000 and 2 000 hours service should be carried out a LUBRICATE DRIVE SHAF When greas ing, use lithium greasing eve ry 6000 hours or every 2 yea 1. By using a grease pump, pump in grease th rough the g rease fittings m arked by the arr ows. 2. Grease t he spider portion until grease come s out from th e cap 3. seal. After gre asing, wipe off any old grease that was pushed out.
When checkin g the positions of t he grease hole s and grease fitting s, ensure that t he machine is stop It is very dang erous to check the positions of th e grea se hole s and grease fittings while the machine Check that g rease hole (1) of the A-frame ( at the rear of the m achine) is matched with greas e fitting (2) of the s pider. If grease ho procedure. 1. Move th e machine forwar d or reverse. Do not g o under the mac hine at this ti 2. Stop the under th 3. Check th at grease hole ( 1) is matched with grease fittin If grease them by hole (1) is not m repeating steps