. OPERATION EXPLANATION OF COMPONENTS the flow of 3 - 31 STARTING SWITCH This switch (1) is used to start or stop t OFF position : The key can be removed from the starting switch, electricity to the e lectrical system is cu t, and the engi ON position : In this position, e circuits. Keep the starting running. lectric current flows in the charging and lamp switch key at ON position while the engine is When turning the starting switch ON or OFF, if the st arting switch is held at a posit ion between ON an d OFF, the co ntroller may detect this as a pr oblem. If this happen s, return the st arting switch to the OFF positio n, then operate it as usual to the O N position.
In cold weather, if the key is turned ON , engine prehe ating starts automatically and the pr eheating pilot lamp lights up. When prehea ting is completed, th e preheating p ilot lamp goes out. START position : This is the position to start the engine. H old the key at t his position while cranking. Release the key immediately after the engine has be en started. The key will return to O N position when released. LAMP SWITCH This switch (2) lig hts up the head lamps , side clearan ce lamps, tail lamps, machine m onitor lighting, and r Position (a): OFF Position (b): Side mach Position (c):
The ine monitor lighting li head lamps light u clear moni ance lamps, tail lamp s, rear lamps, and machine tor lighting. The lamp switch c an be turned to switc h the lighting r egardless of the position of the turn signal lever. TURN SIGNAL LEVE R rates the turn signal lamp. h the lever forward the lever back This lever (2) ope rates the turn signal l (a)Right turn: Pus (b)Left turn: Push When the lever is operated, the turn sig nal pilot lamp also flashes. The lever is auto matically returned w hen the steer ing wheel is and. turned back. If the lever does not retur n, move it by h