26 GETTING TO KNOW YOUR VEHICLE NOTE: M ANUAL S LIDING S IDE D OOR After pushing the door handle button, you must wait two seconds before you can lock or unlock the doors, using either Passive Entry door handle. This is done to allow you to check if the vehicle is locked by pulling the door handle, without the vehicle unlocking. The sliding door may be opened from the inside or the outside. Pull outward on the exterior handle to open the sliding door. The sliding door inside handle functions by rocking forward and back. Rocking the handle backwards opens the door and rocking forward releases the hold open latch in order to close the door.
The Passive Entry system will not operate if the key fob battery is depleted. Push The Door Handle Button To Lock The vehicle doors can also be locked by using the key fob lock button, or the lock button located on the vehicle’s interior door panel Ъ page 387. A UTOMATIC U NLOCK D OORS O N E XIT I F E QUIPPED Do NOT grab the door handle when pushing the door handle button. This could unlock the door(s). The Unlock Doors Automatically On Exit feature unlocks all of the vehicle doors when any door is opened. This will occur only after the gear selector has been placed into the PARK position, after the vehicle has been driven (the gear selector has been placed out of PARK and all doors closed).
1 — Door Handle 2 — Door Lock Side Door Handle And Lock Functions The Unlock Doors Automatically On Exit feature will not operate if there is any manual operation of the door locks (lock or unlock). Do NOT Grab The Door Handle When Locking This feature can be turned on or off in the Uconnect system Ъ page 189.