Ditch Witch / Charles Machine Works RT40 — Attach Product

RT40 Operator’s Manual Plow - 79 Setup p Position Tractor 1. Fasten and adjust seat belt. 2. Start tractor. See page 58 for start-up procedures. 3. Drive to starting point. Move in line with planned trench. See page 60 for operating procedures. 4. Lower backfill blade. 5. Engage parking brake. 6. Lower plow to starting point of trench. 7. Turn ignition switch to STOP. Attach Product To Pull Product 1. Insert material into pulling grip. 2. Tape grip with duct tape. To Feed Product 1. Remove cable guide. 2. Feed cable through tube from top to bottom. 3. Replace cable guide and tighten fasteners. 4. Secure cable. NOTICE: Keep everyone away from material being installed. CMW