Plow - 82 RT40 Operator’s Manual p Operating Tips 11. Move attachment speed/direction control to full speed forward. PLOW WILL VIBRATE. 12. Reduce attachment speed to a point with the least tractor vibration and the highest ground drive speed possible without tire slippage. 13. When installation is complete, move plow swing to neutral. 14. With vibrator running, lower throttle speed and raise plow to ground level. NOTICE: Do not operate vibrator when plow is out of the ground. This will cause excessive vibration resulting in rapid wear, and possible damage to the unit and product being installed. 15. Move attachment speed/direction control to neutral. 16. Engage parking brake. 17.
Lower backfill blade. 18. Turn ignition switch to STOP and remove product from plow. 19. Start tractor, raise backfill blade and drive a short distance away from work site. 20. Shut down tractor. See page 60 for proper shutdown procedures. Operating Tips If material must be at a constant depth, dig starting and target trenches. Check cable for damage during plowing. Run continuity checks on electric cable and check pipe pressure. Damage can result from improper operation, incorrect blade choice, striking underground obstructions, or other conditions. Keep sod cutter edge sharp when plowing in areas with heavy grass cover or surface clutter. CMW