Backhoe - 90 RT40 Operator’s Manual p Setup Setup 1. Move attachment speed/direction control to neutral position. 2. Move ground drive control to neutral position. 3. Engage parking brake if not on level ground. 4. Lower rear attachment to 6” (150 mm) above ground. 5. Check that backfill blade is straight and lower it to ground. 6. Decrease engine speed to low throttle. 7. Move to backhoe operator’s station. 8. Release seat lock (shown) and move seat into operating position. 9. Lower stabilizers enough to lift front tires. 10. Disengage stow lock. 11. Adjust engine speed to 1/2 to 3/4 throttle for digging. t14om084h.eps NOTICE: Engine speed affects speed of backhoe operation. CMW