MACHINE OPERATIONS AND CONTROLS OPERATION Check Oil Level In Hydraulic Tank, Add Oil When removing the oil filler cap, oil may spurt out, so turn the cap slowly to release the internal pressure before removing the cap. 1. If the work equipment is not in the condition shown in the dia- gram on the right, start the engine, run the engine at low speed, retract the arm and bucket cylinders, then lower the boom, set the bucket teeth in contact with the ground, and stop the engine. 2. Within 15 seconds after stopping the engine, turn the starting switch to the ON position, and operate the control levers (work equipment, travel) fully in each direction to release the internal pressure. 3.
Open cover (1) on the left side of the machine and check sight gauge (G). The oil level should be between the H and L marks. NOTICE Do not add oil if the level is above the H line. This will dam- age the hydraulic equipment and cause the oil to spurt out. If the oil is above the H level, stop the engine, wait for the hydraulic oil to cool down, then drain the excessive oil from drain plug (P1). When draining the oil, loosen bottom drain plug (P1), then loosen side drain plug (P2) and drain the oil. After draining the oil, tighten drain plugs (P1) and (P2). (A): Rear 4. If the level is below the L mark, add oil through oil filler (F) at the top of the hydraulic tank. 3-78 WARNING WARNING