Komatsu — REPLACE FUEL FILTER CARTRIDGE

MAINTENANCE MAINTENANCE PROCEDURE EVERY 500 HOURS MAINTENANCE 4 Maintenance for every 10, 100 and 250 hours service should be carried out at the same time. REPLACE FUEL FILTER CARTRIDGE 4 q After the engine has been operated, all parts are at high temperature, so do not replace the filter imme- diately. Wait for all parts to cool down before starting the operation. q High pressure is generated inside the engine fuel piping system when the engine is running. When replacing the filter, wait for at least 30 seconds after stopping the engine to let the internal pres- sure go down before replacing the filter. q Do not bring any fire or flame close.

NOTICE q Genuine Komatsu fuel filter cartridges use a special filter that has highly efficient filtering ability. When replacing the filter cartridge, always use a genuine Komatsu part. q The common rail fuel injection system used on this machine consists of more precise parts than the conventional injection pump and nozzle. If any part other than a genuine Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the injection system. Always avoid using substitute parts. q When carrying out inspection or maintenance of the fuel system, pay more attention than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely.

q Container to catch the oil q Filter wrench 1. Set the container to catch the fuel under the filter cartridge. 2. Using a filter wrench, turn filter cartridge (1) counterclockwise to remove it. 3. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with engine oil, then install to the filter holder. NOTICE q When adding fuel, do not remove cap (4). Always add fuel from the 8 small holes (A) on the dirty side. q After adding fuel, remove cap (4) and install the fuel filter. q Always fill with clean fuel. Be careful not to let any dirt or dust get into the fuel.

In particular, center portion (B) is the clean side, so do not remove cap (4) when adding fuel. Be careful not to let dirt or dust get into center por- tion (B) on the clean side. 4-53 WARNING