HIC900 Throttle Controller Operating Procedures Quick Reference Guide BCP (Battery Charge Protection Mode) Note: This system has been set-up for Automatic Battery Charge Protection , which becomes active whenever the following enabling conditions are met: Fast Idle system will only be turned off when the button is re- leased. ENABLING CONDITION: Vehicle NOT moving (speed=0 MPH). Service Brake NOT pressed. Vehicle Transmission Range in Park/Clutch NOT pressed. RPM's inside of safe operating range. Transmission Fluid Temperature below 240˚ F. Engine Coolant Temperature below 230˚ F.
Brake Lights Functional Foot Off Accelerator Pedal To exit “ AUTOMATIC CHARGE PROTECTION Mode ”, simply depress the service brake pedal. See the Off Road Engineering literature for specifi c details regarding other operating parameters. AUTOMATIC BATTERY CHARGE PROTECTION Any time your vehicle is Powered-up”, Charge Protection is auto- matically engaged, THIS FUNCTION SHOULD NOT NORMALLY BE DISABLED. Charge Protection will remain in effect until which time, any of the above stated ENABLING CONDITIONS are no longer met, or until you manually dis-engage the BCP button on the DRIVERS OVERHEAD CONTROL PANEL, see photo at right.
TO DEACTIVATE AUTOMATIC BATTERY CHARGE PROTEC- TION FAST IDLE” Do the following: Press the Manual Engage button on the DRIVERS OVERHEAD CONTROL PANEL and release. Fast Idle Switch is shown as mounted on Driver’s Overhead Control Panel (ref. page 20) Krystal Enterprises 24 RETURN TO MENU