CYLINDER BLOCK 2-27 FRONT CASE 1. Install the gasket and front case assembly and tighten the bolt to the specified torque. C 1 pieces B 3 pieces A 1 pieces D 2 pieces L4GC039A OIL SEAL 1. Install the special tool crankshaft oil seal guide(09214- 32100) to the front end of the crankshaft. After applying engine oil to the outer surface of the oil seal guide, insert a new oil seal through the guide until it reaches the front case by hand. 09214-32100 L4GC040A 2. Install the oil seal using the special tool crankshaft oil seal installer(09214-32000) (in parallel with front case). 09214 - 32000 L4GC041A 3. Install the crankshaft sprocket, timing belt, and crankshaft pulley. 4.
Install the oil screen. 5. Refer to oil pan gasket and cylinder block gasket . 6. Apply sealant to the oil pan flange groove as shown in the illustration. Sealant groove Bolt hole CAUTION Apply sealant as a thickness of about Φ 4mm. Before 15 minutes is passed after applying sealant, install the oil pan. L4GC042A Items Values Bolt length A 25mm B 20mm C 45mm D 38mm Specified torque 2.0 ~ 2.7kg·m