hyundai — l4gc

MAIN MOVING SYSTEM 2-46 5. Install the bearing cap and tighten the cap bolt to the speci- fied torque from the center in order. (Tighten the bearing cap bolts to the specified torque by tightening bolts step by step 2-3 times equally) When installing the cap, proper number of cap should be installed as well as arrow mark should be directed to the engine crank pulley. L4GC074A 6. Check that the crankshaft for free rotation and proper clear- ance between the center main bearing thrust flange and connecting rod big-end bearing. L4GC075A 7. Using the special tool Crankshaft oil seal installer (09231- 21000) , fully insert the oil seal into the crankshaft rear oil seal case.

09231 - 21000 L4GC076A 8. Install the rear oil seal case and gasket and tighten 5 bolts. When installing, apply engine oil to the oil seal round and crankshaft. 9. Install the rear plate. 10. Install the flywheel, front case, oil pan, and timing belt train. Main bearing cap bolt 2.7 ~ 3.3kg·m+(60° ~ 65° ) Connecting rod cap bolt 5.0 ~ 5.3kg·m Crankshaft end-play 0.06 ~ 0.260mm