hyundai — l4gc

MAIN MOVING SYSTEM 2-52 3. Using a connecting rod aligner, measure bending and tor- sion of rod and if the measured value is around the limit, correct the rod with a press. But when the rod is severely bended or damaged, neces- sarily replace it. Notch L4GC081A ASSEMBLY 1. Using the special tool piston pin setting tool (09234- 33001) , assemble the piston and connecting rod as below. 1) Apply engine oil to the outer surface of the piston pin and small end bore of the connecting rod. L4GC082A 2) With the front mark faced upward, fix the connecting rod and piston and insert it into the piston pin assembly.

Press ram Front mark Installer 3) Using a press, press-fit the piston pin into the pin hole with the specified pressure on the pin end through the push rod. If the pressure is required more than the specified value, follow the next step. Support 09234-33001 Remover Piston Connecting rod Adaptor L4GC083A Bending of connecting rod 0.05mm Torsion of connecting rod 0.1mm Piston side 0 (engraved) Connecting rod side Number (embossed) Press-fit pressure of piston pin 350 ~ 1350kg