hyundai — l4gc

MAIN MOVING SYSTEM 2-54 2) After installing no.2 piston ring, install no.1 piston ring. CAUTION Face the size mark and manufacturer mark on the ring surface upward when installing the piston ring. Take care not to change no.1 and no.2 pis- ton rings. No.1 No.2 L4GC080A 3. Using a piston ring clamp, insert the piston and connecting rod assembly as the cylinder number into the cylinder and face the arrow mark on the piston head toward the engine crankshaft pulley. Install a vinyl cover to the cap bolt not to damage the cylin- der bore and crank pin. Lower side rail gap No.1 ring gap Crankshaft pulley shaft CAUTION Be sure that the piston ring gap is same as shown in the illustration.

If the piston ring gap is normal, gaps are not aligned with direction of piston and thrust and each gap is away from gaps as far as possible. Apply enough engine oil to the piston and pis- ton ring round. No.2 ring gap and spacer Upper side rail gap L4GC087A L4GC088A 4. Install the connecting rod cap and tighten the cap nut to the specified torque. When installing the connecting rod cap, align the cylinder number on the connecting rod big end with cylinder num- ber on the cap. Big end bore size L4GC089A