LUBRICATION SYSTEM 2-62 LUBRICATION SYSTEM OIL PRESSURE SWITCH Oil pressure switch is located on the front right side of the en- gine and if oil pressure in the lubrication system drops less than 0.29kg/cm 2 , the oil pressure warning lamp illuminates. Hexagonal width of this switch is 24mm. REMOVAL AND INSTALLATION Adaptor After applying sealant to the spiral portion, install the oil pres- sure switch. NOTE Do not tighten the oil pressure switch too tight. L4GC030A INSPECTION 1. Using an ohmmeter, measure an electric current and re- place the oil pressure switch if an electric current is not detected. L4GC098A 2.
When pressing it with a thin stick, if an electric current is measured between terminal and body, replace the oil pres- sure switch. 3. When applying a negative pressure of 0.3kg/cm 2 through the oil hole, it an electric current is not measured, the switch is normal. If the switch is not normal, check for air leak. If air is leaked, replace the switch because it means damage of the diaphragm. L4GC099A Oil pressure switch 1.3 ~ 1.5kg·m