Miscellaneous—Machine F1— 10A Start Fuse F2— 10A Spare/Fuel Filter Heater Fuse F3— 15A Start Aid Fuse F4— 10A Horn Fuse F5— 10A Transmission Controller Fuse F6— 7.5A Monitor/Gauge Fuse F7— 15A Heater Blower Fuse F8— 15A Condenser Fan Fuse #1 F9— 15A Condenser Fan Fuse #2 F10— 10A A/C Compressor Fuse F11— 15A Front/Rear Wiper Fuse F12— 15A Left/Right Door Wiper Fuse F13— 15A Spare Fuse (Auxiliary Light) F14— 10A Start Aid Fuse F15— 15A Rops (Under Seat) Heater Fuse F16— 20A Light Circuit Breaker F17— 10A Dome Light, Radio Fuse F18— 10A Radio Fuse (Unswitched) F19— 10A Service Expert Fuse F20— 5A Engine Controller Fuse (Switched Power) F21— 15A Engine Controller Fuse (Unswitched Power) (Located By Alternator) F22— 15A Spare Fuse F23— 10A Fuel Shut Off Fuse (650H) K3—Accessory Relay #3 K4—Heater Blower Relay K5—A/C Relay K7—Horn Relay K8—Transmission Con- troller/Monitor Relay IMPORTANT:
Install fuse with correct amperage rating to prevent electrical system damage from overload. The fuse block is located on right side of machine through access cover. HG31779,00000AF -19-16JUL02-2/2 Drain Fuel Tank Sump CAUTION: Handle fuel carefully. Shut the engine OFF. Do not smoke while you work on fuel system. 1. Remove rear access panel (A). T117851B —UN—26OCT98 2. Remove left fuel sump access panel (B). If equipped with winch, remove both left and right fuel sump access panels. 3. Attach hose to drain cock (C) and route through sump opening. Open drain cock for several seconds to drain water and sediment. 4. Close drain cock. Replace fuel sump panel(s) and tighten cap screws.
650H Shown 5. Install rear access panel, if removed. Tighten cap screws. A—Rear Access Panel B—Left Fuel Sump Access Panel C—Drain Cock T117852B —UN—26OCT98 Left Fuel Sump Access Panel T117853B —UN—26OCT98 03T,55,K88 -19-24APR99-1/1 4-1-15 070813 PN=131