John Deere 450H, 550H, 650H — Electrical System

Miscellaneous—Troubleshooting Electrical System Symptom Problem Solution Starter Will Not Crank Engine Battery disconnect switch turned off Turn switch on. Starter Listen for click from starter solenoid. If click is heard, the starter control circuit is functioning. If click is not heard, see your authorized dealer. Starter relay With vehicle in neutral, open right engine service door and listen for click from starter relay when the key switch is in START position. If click is heard, the key switch, circuit breaker, start fuse connectors, and neutral start switch are functioning and the starter relay, relay ground, or starter is defective. See your authorized dealer.

Starter Solenoid Chatters Poor or corroded connections at battery, battery ground strap, or starter Inspect, clean, and tighten if necessary. Engine Cranks Slowly Loose or corroded battery cables Inspect and clean or tighten. Loose battery ground cable Open battery cover and inspect and tighten battery ground cable. Excessive engine load Change engine oil to proper grade for temperature. Starter Continues to Run Starter solenoid stuck Shut engine off. See your authorized dealer. Starter relay stuck on Shut engine off. See your authorized dealer. Battery Uses Too Much Water Cracked battery case Replace battery. High ambient temperature Fill with distilled water.

Cracked Battery Case No battery hold down clamp Replace battery and install hold down clamp. Loose battery hold down clamp Replace battery and install hold down clamp. Battery hold down clamp too tight Replace battery and install battery hold down clamp correctly. Frozen battery Keep battery fully charged in cold weather. Low Battery Output Low water level Add distilled water. Continued on next page HG31779,00000D3 -19-15JAN08-1/2 4-3-5 070813 PN=161